I recently bought a very sorry looking CPC 464 from eBay which has a very unusual fault.
When I power it on I get this.
The image is black and white because i hooked up a quick dirty composite cable so I could take a screenshot but it’s the same image on the Amstrad green screen monitor.
There are dark blocks at the top which is where the 1984 Amstrad Consumer Electronics normal Basic text is and typing on the keyboard produces the same dark blocks as you type.
If you keep pressing Enter until you get to the bottom of the screen the dark blocks disappear off the top of screen.
Pressing the copy key produces a beep but entering simple basic commands like trying to produce a sound or 10 PRINT “something” - 20 GOTO 10 does nothing.
I tested the DRAMS in a DRAM tester and they all passed.
I bought one of those Dual ROMs where you can switch between standard Basic and a diagnostic ROM (The one created by Noel Llopis).
When I run the diagnostic ROM I can see the test patterns on screen. They are not perfect but cover the whole screen and none of those dots and dashes are there.
When it finishes I get 3 beeps indicating a memory fault but when it gets to the screen that shows me what DRAMS are faulty I get a blank screen with a row of dashes along the very top.
I’ve tried swapping the DRAMs about and I’ve also got an Oscilloscope which I’ve done a bit of probing about with but to be honest I don’t really know what I’m supposed to be looking for as far as what is correct and what is unusual.
The board is a Z70100 and all the DRAMS, CPU, ROM and ULA are all socketed.
I’ve had a look at the solder side of the board for any dodgy joints and verified continuity from the DRAM’s to their relevant connections using the schematics and made sure nothing is shorting.
4.9v on all the IC’s
There were also 2 bodge wires fitted which were just linking 2 ends of a a trace on the PCB.
One from the 5v barrel connector to the connector that goes to the cassette, speaker, power switch, etc.
The other was on one of the pins on the RGB DIN to the other end of it’s track. I don’t know what the point of these were as there was nothing wrong with the original trace on the board so I removed them.
Any help on this one appreciated as I’ve looked online and I can’t find anything relating to anything similar to this issue.
